Full-Text Search:
Home|Journal Papers|About CNKI|User Service|FAQ|Contact Us|中文
《Transactions of the Chinese Society of Agricultural Engineering》 2008-08
Add to Favorite Get Latest Update

Optimized design and experiment of roller-crush board ginkgo huller

Zhu Lixue1,2, Luo Xiwen1, Liu Shaoda2 (1. Key Laboratory of Key Technology on Agricultural Machine and Equipment (South China Agricultural University), Ministry of Education, Guangzhou 510642, China; 2. College of Mechanical and Electrical Engineering, Zhongkai University of Agriculture Engineering, Guangzhou 510225, China)  
To overcome shortcomings of gingko hulling process of roller-crush board huller, low hulled rate, difficulty of crushed mixture, etc, structure of the huller was redesigned. The crush board was improved, two shocking board were put into the crushing facility, and crushed mixture of gingko were separated with wind raising sieve. After 4-factor-2-level orthogonal experiments had been accomplished, key parameter of the hushing equipment had been studied with the quantitative analysis. The result shows that, the cracked nut rate T increases by 9% over before, and can reach 70%. The smashed nut rate S is less than 12%, the rate of remained core in shell dropped to 10% and the rate of remained shell in core go to 8%, while the four key parameters (roller material, rolling interstice, rotate velocity and pre-treating) were adjusted to 45# steel, 10 mm, 1000 r/min and 4 hour under 50℃ infrared drying oven, respectively. A second generation of improved prototype of gingko huller would be implemented based on the experiments.
【Fund】: 广东省科技厅国际科技合作项目(2005B50201008);; 广东省科技厅农业攻关项目(2006B12401021)
【CateGory Index】: S226
Download(CAJ format) Download(PDF format)
CAJViewer7.0 supports all the CNKI file formats; AdobeReader only supports the PDF format.
©2006 Tsinghua Tongfang Knowledge Network Technology Co., Ltd.(Beijing)(TTKN) All rights reserved