Full-Text Search:
Home|Journal Papers|About CNKI|User Service|FAQ|Contact Us|中文
《Iron & Steel》 2013-01
Add to Favorite Get Latest Update

Modeling of Three Freedom Degrees and Failure Simulation of Strip Mill Gauge Control System

DONG Min,ZHOU Bin(College of Mechanical Engineering,Yanshan University,Qinhuangdao 066004,Hebei,China)  
Aiming at the difficult problems that fault diagnosis caused by system parameters change is hard and the practical fault simulation has high cost and danger on strip rolling mill gauge control system,by fully considering the distribution of the mass,stiffness and damping of each part on the strip mill,a three freedom degrees of dynamic simulation model was established by using modular modeling method for gauge control system of strip rolling mill.The model can more fully reflect the system response as the change of system parameters,so it is a fault simulation model with practical value.The typical faults simulation was researched by the dynamic response of the model,the obtained fault feathers can provide a basis for system fault prediction and diagnosis.The measured experimental data verify the correctness and reliability of the model.
【Fund】: 河北省自然科学基金-钢铁联合研究基金资助项目(E2012203110)
【CateGory Index】: TG334.9
Download(CAJ format) Download(PDF format)
CAJViewer7.0 supports all the CNKI file formats; AdobeReader only supports the PDF format.
【Citations】
Chinese Journal Full-text Database 1 Hits
1 Dong Min Liu Cai(Rolling Mill Research Institute, Yanshan University);DYNAMIC MODEL FOR HYDRAULIC SCREW DOWN SYSTEM OF MILL AND THE FAULT SIMULATION DURING BITING COURSE[J];Shanghai Metals;2005-03
©2006 Tsinghua Tongfang Knowledge Network Technology Co., Ltd.(Beijing)(TTKN) All rights reserved